Optimized Multi-input Single-output Energy Harvesting System

Abstract

The energy harvesting sources has been introduced as a promising alternative for battery power. However, harvested energy is inherently sporadic, unstable, and unreliable. For this reason, a non-volatile processor has been previously proposed to bridge the intermittent executions in frequent power losses. Nonetheless, recurrent power failures reduce overall system performance which has forced researchers to look into multi-input energy harvesting systems. The purpose of this study is to investigate the possible solutions to improve the reliability and functionality of battery-less devices. This study has two major objectives: (1) implementing periodic checkpointing on WISP5, and (2) proposing optimized multi-input single-output energy harvesting system. The WISP5 was acquired from the Sensor Systems Laboratory, University of Washington, as a viable RFID energy harvesting system to implement software checkpointing techniques. We performed the periodic checkpointing every 50ms based on the RFID power fluctuation style. Then, we explored a number of possible maximum power point tracking techniques to extract maximum power from harvesters. As a result, we verified that the open circuit voltage control is the most cost effective and efficient technique for both thermoelectric (TEG) and photovoltaic (PV) . Also, we revealed that in low-level input voltages, following the fact that the maximum power extraction can be achieved at half of open circuit voltage does not result in maximum possible efficiency. Therefore, by adjusting the converter input voltage at about 66% of open circuit voltage, we improved power efficiency by about 18%.