Excess foundry sand characterization and experimental investigation in controlled low-strength material and hot-mixing asphalt
Date
2004-10Author
Tikalsky, Paul J.
Bahia, Hussain U.
Deng, An
Snyder, Thomas
Metadata
Show full item recordAbstract
This report provides technical data regarding the reuse of excess foundry sand. The report addresses three topics: a statistically sound evaluation of the characterization of foundry sand, a laboratory investigation to qualify excess foundry sand as a major component in controlled low-strength material (CLSM), and the identification of the best methods for using foundry sand as a replacement for natural aggregates for construction purposes, specifically in asphalt paving materials. The survival analysis statistical technique was used to characterize foundry sand over a full spectrum of general chemical parameters, metallic elements, and organic compounds regarding bulk analysis and leachate characterization. Not limited to characterization and environmental impact, foundry sand was evaluated by factor analyses, which contributes to proper selection of factor and maximization of the reuse marketplace for foundry sand. Regarding the integration of foundry sand into CLSM, excavatable CLSM and structural CLSM containing different types of excess foundry sands were investigated through laboratory experiments. Foundry sand was approved to constitute a major component in CLSM. Regarding the integration of foundry sand into asphalt paving materials, the optimum asphalt content was determined for each mixture, as well as the bulk density, maximum density, asphalt absorption, and air voids at Nini, Ndes, and Nmax. It was found that foundry sands can be used as an aggregate in hot-mix asphalt production, but each sand should be evaluated individually. Foundry sands tend to lower the strength of mixtures and also may make them more susceptible to moisture damage. Finally, traditional anti-stripping additives may decrease the moisture sensitivity of a mixture containing foundry sand, but not to the level allowed by most highway agencies.
DOI
10.2172/861001Citation
Tikalsky, P. J., Bahia, H. U., Deng, A., & Snyder, T. (2004). Excess foundry sand characterization and experimental investigation in controlled low-strength material and hot-mixing asphalt. Report no. DE-FC36-01ID13974. Pennsylvania Transportation Institute, Pennsylvania State University, University Park, PA. https://doi.org/10.2172/861001